Versions
Schlenker guide bush versions are developed to meet specific material, machining and installation requirements. Different versions provide tailored properties such as extended reach, improved sliding characteristics, reduced material adhesion or simplified setup, allowing the guide bush to deliver optimum performance for the respective application.
Versions
- Special material with very good gliding properties
- Prevents welding of the material in the guide bush
- Ideal for material with scratch-sensitive surface
- Especially suitable for material with poor gliding properties e.g. titanium
- Guide bush is made out of one material, so it can be reground several times after wear up to the maximum material clearance diameter
Versions
- Special material with very good gliding properties
- Prevents welding of the material in the guide bush
- Especially suitable for medical steels like titanium and stainless steel
- Alternative to SB design
- Guide bush is made out of one material, so it can be reground several times after wear up to the maximum material clearance diameter
Versions
- Especially suitable for material with poor gliding properties e.g. titanium
- Processing of complex profiles possible
- Prevents welding of the material in the guide bush
Versions
- High wear resistance
- Higher service life
Versions
- Needed for special requirements where the tool has a longer distance to the guide bush carrier
Versions
- Prevents the entry of machining chips into the spring area
